If you’re looking to upgrade your home’s hardware, replacing door knobs is a relatively simple and inexpensive way to do so. However, removing old door knobs can be a bit tricky if you don’t know what you’re doing.
In this article, we’ll walk you through the steps on how to remove an old door knob. We’ll also provide some tips on how to choose the right replacement knob for your door.
Before you begin, gather the following tools:
- Phillips head screwdriver
- Flat head screwdriver
- Hammer
- Safety glasses
Removing the Door Stop Plate
The stop plate prevents the door from swinging open too far and hitting the wall. It is usually attached to the door frame with two screws. To remove the door stop plate, you will need a screwdriver.
- Locate the screws that are holding the door stop plate in place. These screws are typically located at the top and bottom of the plate.
- Use a screwdriver to remove the screws. Be careful not to damage the door frame.
- Once the screws are removed, the door stop plate will be loose. You can now remove it by pulling it straight off of the door frame.
Additional Tips
- If the screws are rusted or difficult to remove, you can try using a penetrating oil to loosen them.
- If the door stop plate is stuck, you can try gently tapping it with a hammer to loosen it.
- Be careful not to damage the door frame when removing the door stop plate.
| Screw Location | Description |
|---|---|
| Top of the plate | Prevents the door from hitting the wall when opened too far. |
| Bottom of the plate | Stops the door from swinging too far in the opposite direction. |
How to Remove an Old Door Knob
Removing an old door knob is a simple task that can be completed in a few minutes with the right tools. Here are the steps:
1. **Gather your tools.** You will need a screwdriver, a hammer, and a pair of pliers.
2. **Remove the screws from the doorknob.** There will be two screws located on the inside of the doorknob. Use a screwdriver to remove the screws.
3. **Tap the doorknob with a hammer.** This will help to loosen the doorknob from the door.
4. **Pull the doorknob off of the door.** Use your pliers to pull the doorknob off of the door. Be careful not to damage the door or the doorknob.
People Also Ask About
How to Remove a Door Knob Without Screws?
If the doorknob does not have any screws, you can use a pair of pliers to pry it off of the door. Be careful not to damage the door or the doorknob.
How to Remove a Broken Door Knob?
If the doorknob is broken, you can use a hacksaw to cut it off of the door. Be careful not to damage the door.
How to Replace a Door Knob?
To replace a doorknob, simply follow the steps in reverse order. First, insert the new doorknob into the door. Then, tap the doorknob with a hammer to tighten it. Finally, insert the screws into the doorknob and tighten them with a screwdriver.
